Get matched with top roofers in Fordyce, AR

Skipping the installation of a drip edge or gutter apron can lead to significant water damage. Without this component, water is more likely to seep under roofing materials or leak behind gutters, damaging the fascia, soffits, siding, and even the interior of your home, such as the attic. Over time, this moisture can cause rot, mold, and deterioration. In colder climates, a missing drip edge also increases the risk of ice dams, which can lead to expensive repairs. A drip edge is an essential part of a roof's drainage system, and some local building codes may even require its installation to protect the home from water damage.

If you choose tile for your roof, take the time to hire a true tile professional. Look at trusted online review sites to find a top-rated roofing contractor. This helps you zero in on great contractors while avoiding ones who bait and switch you with fluctuating bids.

After you’ve narrowed down a few great candidates with reasonable bids, there are some important questions to ask roofers before you hire. Be sure they are licensed, bonded, and insured before signing a contract. Once you find a roofer who checks off all your boxes, you’re ready to get your project started.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Metal roofs have a bad reputation for being loud, even if that's not necessarily true—it's usually only thin tin or sheet metal roofs that are loud during storms. Stone coating adds a layer to the metal that severely cuts down on any noise from rain. In many ways, stone-coated steel roofs are quieter than your average, run-of-the-mill asphalt shingle roof.