Top-rated concrete driveway pros.

Get matched with top concrete driveway pros in Altheimer, AR

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete driveway service project in Altheimer, AR?

Select your specific project to find the pro for you.

Find Concrete driveway pros in Altheimer

SSA Paving
4.6(
14
)
Asphalt Paving - Install

Serving Altheimer, AR and surrounding areas

In business since 1992

Free estimates

Credit card accepted

"If you are looking for the highest quality and value in paving look no further than SSA. I will definitely have them back again if I ever need more tar and chip. Tim and his team did an outstanding job and were a joy to work with. 100% customer satisfaction is their goal and they achieved it with me. Greg M."
Response time1 day
Response rate89%
Recommended by100%of homeowners
Showing 1-10 of 29
Concrete Driveways questions, answered by experts

Regular maintenance will help you avoid costly repairs and early replacement. Clean the driveway surface with a stiff brush and water at least twice yearly, and remove any weeds that try to take root. Additionally, every two to five years, apply a sealcoat—this protects the driveway against damaging UV rays and keeps it looking like new.

Most powerwashing jobs take 2-6 hours, but larger buildings or areas with deep staining may require an entire day.

Yes, you can use a mixture of 1 tablespoon of bleach and a gallon of warm water to clean stubborn stains from brick. Do not use bleach without diluting it in water. Undiluted bleach may cause discoloration. You can use either Oxygen bleach such as OxiClean or chlorine bleach. Always wear protective gloves and eye protection when handling bleach.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Yes, you can, but you’ll need to acquire the right pressure washer tips and cleaning solutions for the job. In particular, you’ll need tips that are capable of lowering the pressure from a max of 3,500 PSI to between 150 and 300 PSI. As for the cleaning solution, look for options that are clearly marked for soft washing rather than pressure washing. 

The Altheimer, AR homeowners’ guide to concrete driveway services

From average costs to expert advice, get all the answers you need to get your job done.