Best brush chipping pros near Prichard, AL

While tipping junk haulers is not required or expected, it is a greatly appreciated gesture for a job well done. Many junk removal companies state that tips are welcome but not mandatory. A good rule of thumb is to tip between 10% and 20% of the total bill, or a flat amount of $10 to $20 per worker. For exceptional service, a tip of $20 to $50 for the entire crew is also appropriate. It is often best to give cash directly to each worker at the end of the job.

Consider tipping if the crew:

• Goes above and beyond your expectations.

• Handles heavy, bulky items or navigates difficult spaces like tight hallways or stairs.

• Works in inclement weather or deals with potentially hazardous materials.

• Takes extra care to protect your home and property.

• Accommodates a last-minute scheduling change.

We always recommend wearing a protective mask when blowing leaves (as well as goggles if possible). Blowing leaves creates a lot of dust, and in many cases that dust contains a bunch of allergens that can make those sensitive very miserable. Even worse, moldy leaves can contain fungi and bacteria that could make humans as animals very sick. Mask up before starting your leaf project, and if anyone is helping you collect the leaves it’s a good idea if they wear a mask, too.

Burning yard waste can be an efficient method for large amounts. However, burning has health and environmental risks. Smoke can aggravate respiratory conditions, expose you to carbon monoxide, and cause irritation. Fire produces greenhouse gases and may start wildfires. Minimize risks by burning clean, dry, natural materials. Stay upwind and monitor the fire closely.

Depending on the method you choose to remove grass, it may or may not matter whether the grass is wet or dry when you perform the task. A dryer lawn will be easier to negotiate with a sod cutter, especially if you're not planning to reuse the turf. However, using a shovel by hand might be a little easier if the ground is slightly damp but not so much that it sticks to the tool.