Best toilet pros near Monroeville, AL

First, check that you have cut off the water supply to your toilet. This is a project that can only be done safely if running water cannot reach your toilet fixture. If you're seeing water trickle out after you've confirmed that the water supply is shut off, you can probably rest assured that what you're seeing isn't a problem. It's common for leftover water to spill out when you're removing your toilet's fill valve. If something goes wrong while you're working on your toilet, you'll need to look at your home's policy to see if your homeowner insurance covers water damage.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

While you might think that phantom flushes are simply eerie, they are bad for your toilet (and wallet). These flushes indicate a leak somewhere in the toilet system that needs repairing. These leaks can cause damage to your walls, flooring, and even your plumbing system. While one random flush every now and then might not seem like a big deal, leaving it unattended can lead to bigger problems. 

The normal water level in a toilet bowl is about halfway full. The water should sit above the P trap drain because this creates a seal and suction. When you flush the toilet, the suction keeps sewer gases from entering your house through your toilet. Anytime the water level is higher or lower than half full, you need to make adjustments or replace broken parts.