Get matched with top deck maintenance specialists in Marion, AL

Typically, most residential wooden decks are designed to support approximately 40 pounds per square foot, including the deck’s weight and any items placed on it. While this is fine for typical use, it is usually not enough to hold the weight of a hot tub filled with water and people. To safely support a hot tub, your wood deck will likely require reinforcement. Therefore, it’s best to have a contractor or a structural engineer assess it before hot tub installation.

While the chemical, copper-based coating on pressure-treated wood offers protection from rot and pests, it’s not a silver bullet. An added sealant will help protect the wood further, though sometimes the wood is treated in a way that causes premature failure, and this is largely out of your control. It’s simply a case of bad luck. Regularly inspect all your house’s wood to look for any cracks or signs of mold and mildew. Getting ahead of the problem is the key to ensuring it doesn’t grow out of control.

If you used regular jointing sand, you can typically walk on the repaired area right away. If you used polymeric sand, wait at least 24 hours before walking on it and 48 to 72 hours before driving over it, depending on the weather. Polymeric sand needs time to fully cure and lock the pavers in place.

It is possible to repair wet, rotted wood, but it depends on the extent of the damage. If the wood is severely decayed, it may be necessary to replace the affected sections entirely. However, if the rot is relatively minor, you can attempt to repair it. Start by removing any wet or decayed wood, allowing the area to dry thoroughly. Then, you can apply a wood hardener or consolidant to strengthen the remaining wood fibers. Finally, use epoxy wood fillers to fill in the damaged areas, shaping and sanding them to match the original wood surface.