Best deck cleaning pros near Hurtsboro, AL

Q: What is the standard spacing for railing spindles or balusters?

• <div><p>Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.</p></div>

Q: Can it get too cold for decking materials?

• <div><p>No. In most cases, it&rsquo;s not colder or freezing temperatures that affect decking materials but the amount of moisture that seeps into the materials as a result. For example, wood decking material is more likely to suffer from rot or decay when exposed to excess moisture from snow or ice. An extreme change in temperature can cause wood to expand or contract, but only if it&rsquo;s not properly treated beforehand. </p></div>

Q: What type of sander is best for sanding a deck?

• <div><p>A random orbital sander is best for sanding a deck because it is easier to handle than other power sanders and is less likely to damage the wood. Most decks are made of types of softwood, so a gentler sanding process is essential to prevent permanent blemishes. For example, belt sanders can gouge softwoods. </p></div>

Q: Can I use deck pier blocks as an alternative to traditional deck footings?

• <div><p>Yes, deck pier blocks can be used as an alternative to traditional deck footings, particularly for small or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks don&rsquo;t require digging or pouring. However, their use is regulated by local building codes, and they may not be permitted in areas prone to high winds, earthquakes, or hurricanes. Always consult your local building codes before choosing them for your deck project.</p></div>

Q: Is Ipe more expensive than Trex decking?

• <div><p>Yes, Ipe is more expensive than Trex decking&mdash;both in terms of materials and installation (plus, Ipe trees are endangered). On average, Ipe decking costs $10 to $25 per square foot, while <a href="https://www.angi.com/articles/what-cost-trex-decking.htm">Trex decking costs</a> $5 to $12 per square foot. Because Ipe is harder to work with, the price of installation is higher, too. For Ipe decking, you&rsquo;ll pay between $20 and $45 per square foot for labor. However, with Trex decking, the labor costs range from $8 to $22 per square foot.</p></div>

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Hurtsboro, AL?

Select your specific project to find the pro for you.

Verified Reviews for Deck Cleaning pros in Hurtsboro, AL

*The Angi rating for Deck Cleaning companies in Hurtsboro, AL is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Deck Cleaning needs.

*The HomeAdvisor rating for Deck Cleaning companies in Hurtsboro, AL is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Deck Cleaning needs.

Last update on March 11, 2024

Top-Rated Deck cleaning pros in Hurtsboro - Updated Nov 2026

Luke's Painting Company

4.4(

)

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2017

Free estimates

Credit card accepted

"Luke was amazing. He gave us a quick quote that was reasonable. He started and worked when he said he would. He kept us updated and sent pictures afterward. The quality of his work was excellent. I was so pleased with his work. He went above and beyond by doing a couple extra things for us as we were out of state. I would and will recommend him to anyone looking for a professional quality painter!"

+76

Recommended by93%of homeowners

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2024

Free estimates

Credit card accepted

"Had a dryer hose problem that XTS Home Works came out the same day to repair. I really appreciated the same day response and the professionalism. They explained all procedures and ensured our complete satisfaction before they left. I will definitely use them in the future and recommend their services to others. They take great pride in their work!"

Response time2 days

Recommended by33%of homeowners

Request Quote

Stedman Brothers Painting LLC

5.0(

)

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2014

Free estimates

Emergency services offered

"Excellent, promt work! Very professional"

+117

Recommended by100%of homeowners

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

Free estimates

"It went perfectly perfect and I will use them again. I certainly recommend them, they went above and beyond and they did a great job."

+12

Recommended by100%of homeowners

Request Quote

Two Guys Pressure Washing

5.0(

)

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2010

Free estimates

"On time and really nice. Did a great job. I will definitely have them back."

+26

Recommended by100%of homeowners

Request Quote

Top-Notch Tidy Services

5.0(

)

Deck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2020

Free estimates

Credit card accepted

"Overall great service. She is very professional very fast and the quality of work was amazing."

Response time1 day

Response rate88%

Recommended by100%of homeowners

Request Quote

Burns Family Home Contractors, LLC

4.6(

)

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2020

Warranties offered

"Very good work and very clean I am satisfied with the work done"

+25

Response time6 hrs

Recommended by56%of homeowners

Request Quote

Best concrete and landscaping

4.3(

)

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

Free estimates

Credit card accepted

"It was great from start to finish. Keith and Stephanie were prompt in contacting me and dependable in showing up on time and completing the tasks. Would recommend and use again."

+23

Recommended by87%of homeowners

Request Quote

KDL Handyman/Service's - Home Facebook

4.0(

)

Deck, Fence, Patio or Porch - Clean and Seal

Serving Hurtsboro, AL and surrounding areas

In business since 2005

Free estimates

Credit card accepted

"I will continue to use them, I have been very pleased with the work."

Response time1 day

Recommended by81%of homeowners

Request Quote

Allstar Painting and Remodeling

4.5(

)

Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Hurtsboro, AL and surrounding areas

In business since 2012

Free estimates

Warranties offered

"Derick was very professional and compassionate. Very pleased with his service"

Response time2 days

Recommended by83%of homeowners

Request Quote

Showing 1-10 of 47

Deck Cleaning FAQs, answered by experts

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

No. In most cases, it’s not colder or freezing temperatures that affect decking materials but the amount of moisture that seeps into the materials as a result. For example, wood decking material is more likely to suffer from rot or decay when exposed to excess moisture from snow or ice. An extreme change in temperature can cause wood to expand or contract, but only if it’s not properly treated beforehand.

A random orbital sander is best for sanding a deck because it is easier to handle than other power sanders and is less likely to damage the wood. Most decks are made of types of softwood, so a gentler sanding process is essential to prevent permanent blemishes. For example, belt sanders can gouge softwoods.

Yes, deck pier blocks can be used as an alternative to traditional deck footings, particularly for small or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks don’t require digging or pouring. However, their use is regulated by local building codes, and they may not be permitted in areas prone to high winds, earthquakes, or hurricanes. Always consult your local building codes before choosing them for your deck project.

Yes, Ipe is more expensive than Trex decking—both in terms of materials and installation (plus, Ipe trees are endangered). On average, Ipe decking costs $10 to $25 per square foot, while Trex decking costs $5 to $12 per square foot. Because Ipe is harder to work with, the price of installation is higher, too. For Ipe decking, you’ll pay between $20 and $45 per square foot for labor. However, with Trex decking, the labor costs range from $8 to $22 per square foot.

The Hurtsboro, AL homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

Deane Biermeier
•
Sep 17, 2026Sep 17, 2026
How Much Does Deck Refinishing Cost? [2026 Data]
Refinishing your deck is a great way to restore its appearance and fall in love with your outdoor space. Use this guide to learn how much it costs based on factors like size and type.
Lauren Bongard
•
Oct 1, 2026Oct 1, 2026
How Much Does It Cost to Pressure Wash a Deck? [2026 Data]
The cost to pressure wash a deck depends on its size, condition, material, and whether you DIY the job. Help set your budget with this cost guide.
Jenna Jonaitis
•
Jul 9, 2026Jul 9, 2026
How to Clean Decking Safely and Naturally
Cleaning your deck at least once a year boosts its durability and appearance. Learn how to clean decking, whether it's wood or composite.
Lawrence Bonk
•
Jul 9, 2026Jul 9, 2026
How to Clean a Deck Before Staining
Learn how to clean a deck before staining to ensure long-lasting adhesion, weatherproofing, and optimum appearance of this coloring and protecting treatment.
Jenna Jonaitis
•
Jul 9, 2026Jul 9, 2026
Top Deck Maintenance Tips for Every Decking Material
Deck maintenance is vital to protecting a wooden deck. Cleaning, staining and sealing a deck after pressure washing will add years to its lifespan. Protect a deck by following these deck maintenance tips for cedar and other types of wood materials.
Jill Harness
•
Mar 6, 2026Mar 6, 2026
How to Clean and Seal Your Deck in One Weekend
Knowing how to clean and seal a deck can help extend its life and keep it looking like new. This DIY guide sheds light on the best way to clean a wood deck.