Get matched with top masons in Equality, AL

Yes, you can technically use a pressure washer to remove paint from brick, but it comes with a significant risk of damaging the brick surface. A high-power pressure washer can be fast but may leave the brick looking unsightly. The recommended method is to first apply a chemical paint stripper, following the product's instructions, and then use a stiff metal bristle brush or a pressure washer on a low-pressure setting to remove the loosened paint. Due to the risk of damage, it is often best to hire a professional who can use low-stress methods.

While painting can certainly change the look of a chimney, you should think twice about giving your brick chimney the old landlord special.

Painting brick is porous, meaning it’s full of tiny holes that can soak up moisture. Those holes also allow it to dry, though. So, when you paint it, you trap any moisture inside, providing an opportunity for mold, mildew, and water damage.

Paint also shows wear faster than naked brick. This means that once you paint a brick surface, you’ll have to keep painting it to maintain a clean look. A paint job is also harder to undo on brick because of its porous nature. Once you paint it, it’s hard to go back without some serious power washing—another added cost.

Yes, brick should be clean before staining to ensure the best results. Dirt, dust, mold, mildew, and other substances on the brick can prevent the stain from properly adhering to it. Thoroughly cleaning the brick allows the stain to penetrate and bond to the surface more effectively. Cleaning typically involves using a pressure washer or a stiff brush with mild detergent. However, stubborn residue may require a specialized masonry cleaner.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.