Get matched with top pressure washers in Lander, WY

Yes, you can pressure wash epoxy garage floors. Most epoxy floors can be cleaned with a mop, but you may choose to pressure wash your floor if it is stained, has ground-in dirt, or is covered with mold or mildew. Before pressure washing, soak stains and dirty areas with a gentle cleanser for best results. Then use a pressure washer tip angled at 45 degrees and raise the spray nozzle to at least 18 inches off the floor to protect the flooring surface. You can also use a surface cleaner power washer or rotary scrubber to prevent overspray. 

Yes, you can pressure wash with just water. The force of the water alone is often enough to remove dirt, grime, and debris from many surfaces. However, for tougher stains like grease, mildew, or algae, adding a detergent or cleaning solution can enhance the cleaning power. Be sure to use the appropriate nozzle and pressure settings for the surface to achieve the best results without causing damage.

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

Most deck lumber is softwood that you can easily damage with the spray from a power washer. Most power washers, though, have a lower pressure setting that’s relatively safe for deck materials if you’re careful to hold the nozzle at least a foot from the surface and continue moving without hovering in one area.