Get matched with top pressure washers in Reliance, WY

Pressure washing a wooden deck can lift ingrained dirt, mold, and mildew, making the space look more inviting and increasing its longevity. However, you risk damaging the porous surface if you DIY deck pressure washing and go in too powerfully or at the wrong angle. Pick a white pressure washer nozzle that sprays with a gentle 40-degree fan pattern, and keep some distance while spraying.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

Hardscaping is made to withstand the elements, but it still needs regular cleaning as well as maintenance like weeding, replacing broken pieces, removing mold or mildew, and more. Use an appropriate cleaner for the hardscaping material with a stiff brush to remove dirt and other material, or use a pressure washer for a deep clean. Staying on top of maintenance can alert you to any problems with your hardscaping that will need repair or replacement.