Top-rated concrete driveway pros.

Best concrete driveway pros near Lander, WY

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete driveway service project in Lander, WY?

Select your specific project to find the pro for you.

Top-Rated Concrete driveway pros in Lander - Updated Nov 2026

Avatar for Bighorn Basin Construction LLC
Bighorn Basin Construction LLC
New to Angi
Concrete Flatwork - Repair & ResurfaceConcrete Patios, Walks & Steps- InstallConcrete Floors - Install+3 more

Serving Lander, WY and surrounding areas

Approved

Free estimates

Small jobs welcome

Offers commercial services

Reliable, detail-driven contractor with a strong work ethic and a reputation for getting the job done right the first time. I specialize in excavation, site prep, landscaping, hardscaping, and concrete work, bringing both skill and precision to every project? Big or small.

17 neighbors recently requested a quote
Avatar for Elk country concrete LLC
Elk country concrete LLC
2.8(
2
)
Concrete Driveways & Floors - InstallConcrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install+4 more

Serving Lander, WY and surrounding areas

In business since 2021

Free estimates

We pride our company on reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business! Thank you!

Response rate100%
Recommended by50%of homeowners
Diamond Custom Design Build
4.0(
5
)
Concrete Driveways & Floors - InstallConcrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install+4 more

Serving Lander, WY and surrounding areas

In business since 2008

Free estimates

Warranties offered

"Dutch and his partner, Mike, put down our hardwood flooring for us in just a few days! Before our floor was laid, they took a wall down in our kitchen which gave us a wonderful open "great room". They were incredible workers. Dutch has so much experience that he was able to figure out some real tough situations we had with wiring and plumbing after the wall was down. Mike was excellent at crawling up in the attic and helping Dutch reroute all the exposed wiring. I've never seen two guys work so hard and put in such long days. They were incredibly fast at their work and I would highly recommend them for any remodeling job. Very nice guys!"
Natural Stone Veneer
Complete Gas Install
Sundeck 5 Tiers
Lodge Frame
Rondeau Project

+14

Recommended by100%of homeowners
Showing 1-10 of 17
Concrete Driveways FAQs, answered by experts

The best driveway cleaner for oil stains depends on the type of surface and the severity of the stain. An absorbent abrasive like baking soda works for many circumstances. By following up the baking soda with a white vinegar rinse, you can increase the effectiveness and ideally remove the stain for good. Concrete oil stains may respond better to oil stain removers designed specifically for concrete if the stain is tough to remove with at-home ingredients.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

You can clean light stains off of concrete using a pressure washer with 2,000 psi, or you can clean tougher stains if you use a smaller nozzle and point the wand closer to the stain. You may also need to go over the surface more than once for a deeper clean. If you want to clean concrete faster, consider using a pressure washer with a psi of 3,000 or higher.

Maintaining a driveway depends on its material. For concrete and asphalt, it's best to clean the surface thoroughly twice a year with a stiff broom and a pressure washer to remove accumulated dirt and debris. Sealing the driveway is crucial to protect it from water damage and freeze-thaw cycles. Before applying a sealant, pressure wash the surface to remove any loose sealant, dirt, or stains, as sealing over them will trap them. Any cracks or expansion joints should be filled with a flexible polyurethane caulk or asphalt sealer. In colder climates, use sand instead of salt for de-icing. Sand helps melt snow and ice without accelerating the freeze-thaw process, which can cause cracks.

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

The Lander, WY homeowners’ guide to concrete driveway services

From average costs to expert advice, get all the answers you need to get your job done.