Question 1

Can you have both a water softener and a water filter?

Accepted Answer

•

Yes, you can have both a water softener and a water filter. In fact, some manufacturers sell dual water softening and filtration systems that treat hard water and provide clean drinking water. If you’re unsure about what you need or want to discuss your options, reach out to a local water softener installation company.

Question 2

How much does it cost to replace a water softener?

Accepted Answer

•

Replacing a water softener costs $200 to $6,000, depending on the capacity of the water softener, the type of water softener, and the amount of people living in your home. An ion exchange water softener is the most common type and costs $500 to $3,000. Water distillers, which cost $1,200 to $4,000, and dual-tank models, which cost $1,000 to $5,000, are definitely pricey, but they offer more filtration or capacity, respectively.

Question 3

Do you need a permit or license to install a water softener?

Accepted Answer

•

Whether you need a permit or license for a water softener installation depends on your location, as requirements vary significantly. Some municipalities require the installer to hold a plumbing license, some mandate a permit and an inspection, and others require both. In some areas, no special permit or license is needed at all.

To determine the rules in your area, you can contact your local building department or consult a local water softener installer or plumber. Often, only certified professionals are authorized to pull the necessary permits, and they will typically handle the entire permitting process for you. Regardless of local laws, it is always recommended to hire a licensed professional to ensure the system is sized and installed correctly. You can use Angi’s state licensing tool to check an installer’s license status.

Question 4

What prevents water spots on glass shower doors?

Accepted Answer

•

You can use a commercial water repellent treatment for glass on your shower doors to prevent water spots. Take care to only apply the product to glass. Letting air circulate also helps prevent water spots, as water is less likely to remain on the glass for a long time with good air circulation. Run your vent fan, open a window, and leave the shower door open for about half an hour after using the shower.

Question 5

How do I install a water softener system?

Accepted Answer

•

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips.

The process of inspecting your water softener system is similar.