Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Arapahoe, WY

Enter your ZIP and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Arapahoe, WY?

Select your specific project to find the pro for you.

Verified Reviews for Bathtub Restoration pros in Arapahoe, WY

*The Angi rating for Bathtub Restoration companies in Arapahoe, WY is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Bathtub Restoration needs.

*The HomeAdvisor rating for Bathtub Restoration companies in Arapahoe, WY is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Bathtub Restoration needs.

Last update on December 03, 2025

Find Bathtub restoration pros in Arapahoe

Avatar for American Tubs....

American Tubs....

2.33(
3
)

American Tubs....

2.33(
3
)
Customers say: Terrific value
2012 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

Refinished bathtubs typically need to be refinished every five years or so. Frequent cleaning and use will break down the finish and make cracks and chips appear more readily. Cracks and chips tend to grow once they begin unless they are repaired immediately. Ideally, you should refinish your bathtub before it gets old enough that refinishing isn’t worth the hassle.

When it comes to cleaning bathrooms, bleach usually comes to mind. But like ammonia, bleach can damage acrylic tubs. In fact, many tub manufacturers warn against using bleach on acrylic bathtubs, and doing so could void the warranty on your tub. Again, a gentler cleaner specifically made for acrylic tubs, or one of the homemade methods listed above, is your better bet here.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

The difference between resurfacing and refinishing is that refinishing only works on solid surfaces that are in good condition, whereas resurfacing will restore a cracked or worn surface to its original, blemish-free state. Refinishing will leave you with a smooth and glossy surface you can’t get from resurfacing alone. If that’s the look you’re going for, contact a local concrete finishing contractor to achieve it.

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

The Arapahoe, WY homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles