Get matched with top deck cleaning pros in Monongah, WV

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

It is recommended to clean your deck once or twice a year to prevent the accumulation of dirt, debris, mold, and mildew. The ideal times for cleaning are in the spring and fall. A spring cleaning removes grime that has built up over the winter, preparing your deck for summer use. A fall cleaning washes away messes from summer activities, preventing them from setting into the wood over the winter. The exact frequency can depend on factors such as how often the deck is used, its exposure to pollen, and whether salt was used on it during the winter. Regular cleaning helps protect the wood and its finish from damage.