Get matched with top paving pros in Gassaway, WV

The main difference between asphalt and blacktop is that asphalt has a lower ratio of bitumen—a low-grade tar-like crude oil—than blacktop. While blacktop is heated to 300 degrees or more, hot-mix asphalt is heated to a lower temperature, typically between 275 and 300 degrees Fahrenheit. Consult an asphalt driveway professional about which type of material is the best fit for your future asphalt driveway.

You should place a layer of thick landscaping fabric directly over the concrete slab and then a thin layer of leveling sand over that to protect the pavers from moisture. For border pavers, you should plan on locking them in place with polyurethane adhesive. This will prevent them from shifting under foot traffic.

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

While water-related pressure caused by poor drainage is one common cause of paver cracking, other factors can include ground movement beneath pavers, heavy loads and wear and tear over the pavers, and climates with constant freeze-thaw cycles. In general, pavers should be resealed every three to five years to prevent cracking.