Get matched with top solar panel pros in Elkview, WV

"The whole process was great! My family and I were very pleased with the friendly service. On top of all that, fantastic results with the installation of the solar panels."

"Excellent work, fair price and great communication. I highly recommend Flash Electrical."

We provide residential and commercial solar power options, and provide support services for industry partner companies. We offer no cost consultations and $0 down financing. Please contact our office for a consultation at (931)922-8258.

Rated #1 in Kanawha Valley by the 2018 Daily Mail Gazette. Willing to do small repairs and general maintenance. When the lights go out or the heat stops working this winter, always count on the technicians to Wm Jean Electric to shed some light on your problems. State licensed and fully insured. Additional Email: [email protected]. DBA: WM Jean Electric Co.

"WE lose signal when it storms, but only for a very short time. A little expensive compared to Dish, but the programming is much better.
"

Discover the extraordinary opportunity to harness solar energy for your electricity needs, with our highly competitive starting rate of only $20 per month. Take advantage of this exclusive offer to determine your eligibility today and unlock the potential savings. As an added incentive, upon qualification, you will receive a generous $1000 Visa gift card, further enhancing your solar experience. Rest assured, our commitment to your utmost satisfaction is unwavering. Additionally, we proudly extend the lowest rates in the industry for roofing solar solutions. Join us and embark on a remarkable journey towards energy efficiency and cost savings.

"Very Unprofessional, Poor customer service and I would not recommend."

"This work was done through Choice Home Warranty, with the repair being given to Sears Services. The first Technician diagnosed the problem as being the heating element on the bottom of the ice maker not working, so the dumping motor was under stress to push out the ice from the tray. The ice maker was replaced and tested fine. However, the new ice maker was a new model (the freezer is 13 years old) and appeared to be identical except that the ice maker plug cover did not connect to the freezer wall to cover the plug. The cover was left pushed down on the electric cord and in the path of the back finger that pushes out the rear cube. That stopped the ice maker from working. Only notice it about 30 minutes after the Technician left. Called within hours but had to wait a week for the next appointment. That second appointment was postponed due to an illness of the Technician and pushed back to the following week. The Technician who came completely removed (cut off) the plug cover, which may not have been necessary. I think it would have been possible to cut off the 2 inserts molded into the cover intended to snap into slots in the freezer wall (the old cover used screws to hold it to the wall) and cover the plug and the multi-colored wires going into it. Now all that is visible. I also had the second Technician adjust the side-by-side, separate framed refrigerator and freezer as they had been misaligned by a prior Technician. The magnetic spacer between the units was preventing the refrigerator door from properly closing. The Technician was thorough in his work, removing the bottom panel of the frame kit to get to the levelers on the bottom of the units and also be able to grab and shift the units into alignment. After he left we noticed that the refrigerator door, though closing properly, seems to be easier to open . . . . like the magnetic seal is not as strong. The door closes tight but just seems different. Don't know why."

"The last was a rental company that we have and we used them for an air conditioning and heating system. It was Bototach Mechanical. It’s been a good program for us. They’re very responsive. I don’t know what the thought process was. My husband said, well let’s try these guys and so we did. We have an older home and it’s proved to be a very good deal. The quality has been pretty good, so I would give them an A for the quality. I will give you one helpful hint though. If the company decides they want to replace an appliance, you need to call them and negotiate with them because you can upgrade, but you need to talk to them in person not just do it over the internet."

"Very professional job.  Product quality appears to be very good and the service was excellent and professional.  Timely and good communication.  I'll be calling them to do the other windows in my home."