Top-rated asphalt driveway pros.

Best asphalt driveway pros near Chester, WV

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Chester, WV?

Select your specific project to find the pro for you.

Top-Rated Asphalt driveway pros in Chester - Updated Nov 2026

Avatar for TCB Paving LLC
TCB Paving LLC
4.3(
79
)
Asphalt Paving - InstallAsphalt Paving - Install- For Business

Serving Chester, WV and surrounding areas

Approved

Super Service Award Winner

In business since 1989

Free estimates

Warranties offered

"TCB applied asphalt over existing driveway to level dips and irregularities. Richard was prompt in his initial reply, quoted over the phone, and started the job the next day. Crew was personable, efficient, and tidy. Driveway looks nice.."
Asphalt
Paving
Blacktop
A
B

+8

Response time2 days
Response rate87%
49 neighbors recently requested a quote
Avatar for Kline Home Exteriors & Restorations
Kline Home Exteriors & Restorations
4.8(
28
)
Gravel or Loose Fill Paving - Install, Spread or ScrapeGravel or Loose Fill Paving - Install, Spread or Scrape - For Business

Serving Chester, WV and surrounding areas

In business since 1992

Free estimates

Emergency services offered

"Excellent Service. Mr. Knox communicated everything up front and was very knowledgeable. He went above and beyond to make sure that my elderly mother's roof was repaired properly. From start to finish I would give him an A+ on all facets of his communication and the company's workmanship. Go with them, you won't be disappointed."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+37

Recommended by96%of homeowners
Showing 1-10 of 31
Asphalt Driveways FAQs, answered by experts

In most cases, you don’t need a permit to repave your driveway, although some exceptions exist. If you’re widening your driveway and plan on widening the apron as well, you’ll usually need a permit from the Department of Transportation in your area. This permit costs between $50 and $300 in most cases. Most municipalities will also require a certified and insured contractor do the work relating to the apron and curb cut. You can contact your building department or ask your paving company if you need a permit. Your driveway professional will usually pull the permit for you.

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

This creates a risk for your driveway to fail after asphalt curing because it doesn't have a lasting bond with the surface. In order to get asphalt to perform as intended, it's necessary to prepare the dirt surface correctly first. The loose soil base under the new driveway must be compacted until it is stable enough to support the weight of the asphalt.

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

The cost to pour a driveway apron depends on the material and size. Concrete costs $3 to $10 per square foot, asphalt ranges from $2 to $5, and pavers are $5 to $15 per square foot. Additional expenses, like excavation, base material, and labor, can increase the total cost. For example, a standard 12x15-foot concrete apron could cost between $540 and $1,800, depending on local rates and additional work required. Always consult a local driveway paving contractor to get an accurate estimate tailored to your project.

The Chester, WV homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.