Top-rated pressure washers.

Best pressure washers near Beverly, WV

Enter your zip and get matched with up to 5 pros

Need a pro for your pressure washing project in Beverly, WV?

Select your specific project to find the pro for you.

Top-Rated Pressure washers in Beverly - Updated Nov 2026

Avatar for Highland Contracting
Highland Contracting
4.5(
22
)
Exterior Surfaces - PowerwashingExterior Surfaces - Powerwashing - For Business

Serving Beverly, WV and surrounding areas

In business since 2020

Free estimates

Small jobs welcome

"When I talked to them I told him that I wanted the house and the deck and patio and the fence around the deck and patio power washed. They did not do the deck nor the patio for he said it was not included in the price! They came without a ladder to power wash a two-story house and had to be provided with one!"
Response time2 days
Response rate100%
Recommended by100%of homeowners
Avatar for Chuck Huggins Inc
Chuck Huggins Inc
4.4(
25
)
Exterior Surfaces - PowerwashingExterior Surfaces - Powerwashing - For Business

Serving Beverly, WV and surrounding areas

In business since 1992

Free estimates

"Chuck returned my call within 2-3 days and came over and we discussed what needed to be done. He returned with an estimate within a day or two. We arranged for a start date and he and his team were on site at the agreed upon day and time. They pressure washed all the woodwork, ceiling and siding on the porch; they scraped, caulked and primed. There was a lot of scraping, especially the wood railings. A lot of attention was paid to the prep. Everything was topped off with a couple of coats of beautiful paint. They even suggested a wonderful contrasting color for the brickwork which turned out very nice. In addition, they cleaned and painted the concrete steps as well as filled in some gaps with concrete between the steps and the foundation. I was very please with how they cleaned up everything when they were done too. The job was done in 3 days."
Brochure 1 of 2
Brochure 2 of 2
Before
During
After

+11

Recommended by100%of homeowners
H20 pressure washing service's
4.0(
2
)
Exterior Surfaces - PowerwashingExterior Surfaces - Powerwashing - For Business

Serving Beverly, WV and surrounding areas

In business since 2019

Free estimates

H20 Pressure Washing Service's is here for all of your Pressure-Washing, Lawn Care and Landscaping needs. We are locally owned and operated with dedication to getting the job done right. We offer free estimates so don't hesitate, give us a call or click for an estimate today.

Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+7

Recommended by100%of homeowners
Showing 1-10 of 46
Pressure Washing FAQs, answered by experts

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Yes, it is important to wash your deck before painting to ensure the paint applies well and adheres properly. While you don't have to use a pressure washer, it is one of the most efficient cleaning methods. Pressure washing can quickly remove dirt, wood fibers, and flaked paint, getting deeper into the wood than manual scrubbing. You can also clean the deck with a stiff broom and a cleaning solution. Regardless of the method, a clean surface is essential for good paint adhesion. Make sure the deck is completely dry before applying any paint.

Yes. You can pressure wash pavers. However, you risk damaging them if you use too much pressure or get too close. Use a PSI of 1,500 and spray the water at least 24 inches away from the surface.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

If you don’t use the right PSI setting for your fence’s material, then yes, pressure washing can ruin your fence. Specifically, if you use a PSI that's too powerful, you may permanently damage a fence. Pressure washers can also remove paint from fences, though this can be a great thing if you’re looking to restore an old wood fence.

The Beverly, WV homeowners’ guide to pressure washing services

From average costs to expert advice, get all the answers you need to get your job done.