Get matched with top countertop and backsplash pros in Two Rivers, WI

You don’t need a cutting board. In fact, cutting is the original purpose of butcher block countertops. That said, wood is porous and can harbor germs. You’ll need to clean your countertop thoroughly after use. Knives can also scratch the surface. This adds to the patina of the wood, but not everyone likes the look—in which case, you may want to use a cutting board.

Fortunately, there are many types of heatproof countertops. Granite, quartzite, concrete, and stainless steel are all fiery contenders. These surfaces work best in busy kitchens where hot pots, pans, and baking sheets are part of the daily routine. Plus, their durability means you get a long-lasting work surface that won’t flinch at a bit of heat or heavy use. However, many stone and concrete counters require a sealer, which is typically not heatproof.

The frequency for sealing granite countertops depends on several factors, including the type of sealant used, the color of the granite, and how heavily the countertops are used. As a general guideline, resealing is often recommended every 12 to 18 months, but some sources suggest it could be as often as every few months or at least once a year.

The type of sealant is a major factor: water-based sealants may need reapplication every six months to a year, while more durable solvent-based sealants can last for five to 10 years. Additionally, factors like heavy kitchen traffic, frequent use of acidic cleaners, and lighter granite colors may require more frequent sealing to prevent staining.

To determine if your countertops need resealing, you can perform a simple water test. Place a few drops of water or a wet paper towel on an inconspicuous area of the granite. After 10 to 15 minutes, check the spot. If the water has beaded up, the seal is still intact. If the water has been absorbed and darkened the stone, it's time to apply a new coat of sealant. You can choose to seal the granite yourself or hire a professional to ensure it's done correctly.

You attach solid surface counters with construction adhesive. Once your slab is ready, you fit it to the wall, apply the adhesive, and secure it in place with clamps until the glue dries. This usually takes several days. 

Afterward, you install the backsplash, faucets, and more. At this point, you can caulk the counter, allow it to dry for 24 hours, and then you're done with the installation.