Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Ridgeland, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Ridgeland, WI?

Select your specific project to find the pro for you.

Find Deck cleaning pros in Ridgeland

Severson, Inc.
5.0(
1
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Ridgeland, WI and surrounding areas

In business since 2003

Free estimates

Warranties offered

"My professional window installers were prompt, courteous, friendly and most importantly knowledgeable. They were able to answer my concerns and questions before during and after installation. The rooms were left clean and orderly. The yard and carport where the windows were stored after delivery by Lowe's was spotless, the old windows, trash and debris were gone! Very impressed! When we signed the paperwork for an installer we didn't know we were getting an entire company with Severson, Inc. Thank You Denise Capps"
Looking Down to the Kitc
Kitchen from Living Room
View from Loft
Kitchen
Recommended by100%of homeowners
Showing 1-10 of 32
Deck Cleaning questions, answered by experts

Staining and sealing the underside of a deck creates a moisture barrier but traps water in the boards, quickly leading to rot. No matter how well you seal the above deck, water still gets through via nails and screw heads on the surface. Allow this water to flow naturally under the deck, where it is routed through the drainage system.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.

When building a deck, #2 grade lumber is a go-to for several reasons. It’s strong, budget-friendly, and works well for most framing and decking needs. But upgrading to #1 or Appearance Grade can give your deck that extra visual edge if you're after a cleaner, more polished look for high-visibility spots.

Routine cleaning, sealing/staining, and inspection prolong deck life and appearance.

The Ridgeland, WI homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.