Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Reeseville, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Reeseville, WI?

Select your specific project to find the pro for you.

TRUSTED BY REESEVILLE, WI HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon38
    Verified deck cleaning services reviews

Find Deck cleaning pros in Reeseville

J J Construction
3.0(
2
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Reeseville, WI and surrounding areas

In business since 1999

Free estimates

"The contractor and an assistant were very energetic and did not hesitate to perform the pressure blasting of the greasy dirty mess on my tractor. They were concerned about the electrical system and radiator and suggested ways to clean those areas. Decisions were up to me. They worked at the job until finished without complaint. The cost of the cleaning was very reasonable for the time and effort expended."
Recommended by50%of homeowners
Showing 1-10 of 22
Deck Cleaning questions, answered by experts

In the majority of cases, you don’t need regulatory permission or permits to remove decking components and materials. However, the exception is if you live in or near a wildlife conservation area, which could require permits and consent prior to beginning the demolition. Check with a local regulatory agency for more information.

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.

Rotting wood, loose railings, or unstable stairs may indicate a need for expertise.

When deciding if you should use 2x6 or 2x8 deck joists, consider the size of the deck, joist spacing, and materials. Larger decks, larger-spaced joists, and weaker wood all require more support, meaning they need larger joists. For example, 2x8 redwood joists spaced 16 inches apart can only safely span up to 10 feet and 7 inches. On the other hand, 2x10 southern pine joists spaced 12 inches apart can be as big as 16 feet and 2 inches. If you aren’t sure what size joist is best for your project, speak with your deck builder.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

The Reeseville, WI homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.