Top-rated floor polishers.

Get matched with top floor polishers in Oshkosh, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Oshkosh, WI?

Select your specific project to find the pro for you.

Find Floor polishers in Oshkosh

Avatar for Bright Day Cleaning Services
Bright Day Cleaning Services
3.2(
16
)
Clean & Polish Flooring - For Business

Serving Oshkosh, WI and surrounding areas

In business since 2013

Free estimates

Emergency services offered

"They did an amazing job, and worked very hard. They showed up an hour late...and for the deep clean service were there for 6.5 hours (didn't even get to the inside of our fridge, and I didn't have them change bed linens). However, they were very friendly and our house looked wonderful! I would recommend them and use their services again!"
Response time2 days
Response rate96%
Recommended by83%of homeowners
Showing 1-10 of 13
Floor Polishers questions, answered by experts

Steam mops can be a better option than traditional mops because the steam can lift stubborn dirt from floors without using chemicals, and it also kills bacteria and dust mites. However, steam mops have drawbacks: they are more expensive, require an electrical outlet, and are not suitable for all flooring types, such as laminate or hardwood, which can be damaged by the steam.

Regular mopping can also sanitize floors effectively when done with the right cleaning products and techniques, though it may require more effort. The main advantage of a traditional mop is its versatility, as it can be used on any type of flooring. Ultimately, the best choice depends on your floor type, budget, and cleaning preferences.

Suggesting regular dusting and spot cleaning to maintain freshness.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The Oshkosh, WI homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.