Top-rated stucco pros.

Get matched with top stucco pros in White River Junction, VT

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in White River Junction, VT?

Select your specific project to find the pro for you.

Find Stucco pros in White River Junction

Vision It Builders
New to Angi
Synthetic Stucco - Install or Completely ReplaceTraditional Stucco - Install or Completely ReplaceTraditional Stucco - Repair or Partially Replace

Serving White River Junction, VT and surrounding areas

In business since 2003

Vision It Builders has many years experience in the residential home improvement field. We take pride in our quality work and ensure 100% customer satisfaction on every completed job. We handle small repairs to full blown remodel and addition projects. If you have a home improvement project use Vision It Builders.

Stucco questions, answered by experts

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

Stucco will dry in two to three days, but you should wait one to two months to allow it to cure fully before you paint it. The curing process is slow, but leaving the material exposed to air and natural moisture will help it reach its maximum strength. If you live in a hot, arid climate, wait a month before painting. Wait two months before painting if you live in a more moderate or wet climate.

The White River Junction, VT homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.