Top-rated buffing and polishing pros.

Get matched with top buffing and polishing pros in Orange, VT

Enter your ZIP and get matched with up to 5 pros

Need a pro for your buffing and polishing project in Orange, VT?

Select your specific project to find the pro for you.

Find Buffing and polishing pros in Orange

Autobody that has over 40+ yrs experience in the auto industry. Stop in anytime Mon-Fri 8-5 for a free estimate.

Buffing and Polishing questions, answered by experts

Quartz is an engineered stone offering a nonporous surface. Quartzite is a natural stone composed of sandstone, making it highly resistant to heat. Additionally, quartz is lower maintenance, while quartzite often requires sealing and more careful upkeep.

Quartzite countertops are porous, meaning that liquids can seep into the stone and stain them. You’ll need to seal them before installing and resealing annually, depending on use and stone material. Sealing will help prevent stains and etching. On the other hand, you don’t need to seal quartz and other engineered stone countertops since they aren’t porous.

If you would rather use vinegar to clean the stone fireplace instead of dish soap, this mixture should work fine. Vinegar is slightly acidic, however, so it may etch some kinds of stone without quite a bit of diluting. For a stone fireplace, dilute it to about one cup of vinegar for every gallon of hot water. It’s a smart idea to test the diluted mixture in an inconspicuous area of the fireplace and watch for etching. You can use vinegar to clean quite a few different items around your home, and it’s especially good at removing stains.

In most cases, chipped or cracked granite can be salvaged, but it depends on the size and scope of the damage. For example, a pro can smooth out small chips on the edge with polish pads or an angle grinder, but a crack that runs through the stone's surface has little-to-no chance of being fixed easily.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The homeowners guide to home care is here

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"