Get matched with top buffing and polishing pros in Milton, VT

To clean stone tiles, first sweep or vacuum to remove dirt particles. Use a mild, pH-neutral detergent and warm water to mop. Be careful not to use acidic cleaning solutions, such as vinegar and lemon juice, which can damage the surface.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Yes, stains can often be removed using a poultice paste that draws out the stain. The paste is applied, allowed to dry, and then removed, lifting the stain from the stone.

You don’t need to seal German smear; the mortar is already acting as a sealant for the bricks. You can seal the mortar, though, if you wish to further protect the area from stains, moisture, and dirt or make it easier to clean and maintain. Note that a sealant will make the mortar appear more glossy.