Get matched with top pool and spa technicians in Johnson, VT

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.

Many people find saltwater tubs worth the upfront expense. They cost less to maintain than traditional hot tubs, so you can save in the long term. Maintenance is also easier, typically involving balancing the pH and cleaning the tub rather than adding chemicals. They’re also gentler on sensitive skin, and you won’t walk away with a strong chlorine odor.

Vinegar can be used as an all-purpose cleaner for many things, including hot tub filters. Soaking hot tub filters in vinegar and water for up to 24 hours can remove dirt and oil, and as a bonus, it won’t cause the water to foam after you reinstall it if there’s vinegar left on it. But make sure you still rinse it to remove any debris, dirt, or grime stuck on it.

For a fully-foamed hot tub, freezing typically occurs when the temperature drops below 28 degrees Fahrenheit and remains at or below this level continuously for a minimum of 36 hours. If your hot tub and pumps are still operational, however, the water circulates, and this continuous movement helps prevent freezing, even in very cold conditions. This circulation, along with the insulation provided by the foam, helps maintain the water temperature and prevent it from freezing during extended cold periods. Still, if you’re not planning to run it regularly, be sure to winterize the hot tub properly to prevent damage from freezing.