Get matched with top drain cleaners in Burke, VT

Start by pouring hot—but not boiling—water down the drain. The heat of the water may be enough to break down the clog. You can also try ½ cup of dish soap or 1 cup each of white vinegar and baking soda. If you choose a chemical unclogging product, ensure it’s appropriate for toilets to avoid damage.

Anything from debris, rust, ice, and even poor installation can cause clogs in your plumbing vents. Some signs of a clog include slow drains, gurgling sounds in drains and toilets, and bad odors. The bad odors are the most concerning, as these can include methane and hydrogen sulfide. Contact a plumber to come take a look if you notice any of these signs.

In some cases, operating a snake can damage your drain and pipes. This depends on the overall condition of your pipes and how gently you operate the auger. For instance, older galvanized pipes covered in zinc are susceptible to scratches when using a drain snake. Additionally, it’s common for newbies to apply too much force when extending the snake, leading to scratches and related damage. You can also crack the porcelain with an electric auger if you’re snaking a toilet drain. If you’re using a manual snake or auger, the risk is minimal.

A good option for opening up and cleaning a sink drain is to use a ¼ cup of baking soda and 1 cup of white vinegar, along with a rubber stopper to cover the drain while those materials work their magic. After about 15 minutes, you can flush the drain with hot water. In many cases, these materials can scrub out minor clogs and get the drain working properly again. If the issue persists, call in a plumber near you to get the problem permanently fixed.