Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Bridport, VT

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Bridport, VT?

Select your specific project to find the pro for you.

Find Deck cleaning pros in Bridport

Avatar for Vermont Pressure Washing - Home  Facebook
Vermont Pressure Washing - Home Facebook
4.6(
8
)
Deck, Fence, Patio or Porch - Clean and Seal

Serving Bridport, VT and surrounding areas

In business since 2007

Free estimates

Credit card accepted

"They were very professional and dedicated. Some of the decks were in pretty bad shape. They stayed on it until all old mold was out. One of them was in sch bad shape that when it was wet it was dangerous. Well now it looks like new. Very nice work. Thank you!"
Dryer vent
Dryer vent
Dryer vent
Saint Johnsbury pressure washing
Saint Johnsbury pressure washing

+21

Response time3 days
Recommended by100%of homeowners
Showing 1-10 of 20
Deck Cleaning questions, answered by experts

Deck boards should be spaced no more than three-eighths of an inch apart. This is enough space to allow water and small debris to pass through without collecting on the surface, but not enough to create a tripping hazard. Certain materials, like pressure-treated wood, shrink over time, so they may need less space at installation.

Most building codes list a minimum width of 36 inches and a maximum height of 7¾ inches. However, for the most comfort and spaciousness, you’ll want to aim for a width of at least 48 inches and a height of 7 inches. Again, it’s always a good idea to base your numbers off steps that you already use comfortably.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

You can nail or screw composite decking, but 3-inch decking screws are the better fastener choice. Unlike nails, decking screws won’t back out of the composite material over time. There’s also little danger of splitting composite material when driving screws, so you don’t need to pre-drill holes unless otherwise recommended by your decking manufacturer.

Yes, Ipe wood is a popular high-end choice for pool decking. It repels water and is naturally slip-resistant. It's not susceptible to mold, mildew, or rot, either, so it lasts longer and is cleaner and more hygienic than other popular decking materials. However, remember that due to its status, it is a very high-cost wood, and you might find that an alternative would serve you just as well for significantly less.

The Bridport, VT homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.