Get matched with top lighting pros in Newport, VA

Replacing a pool light costs about $625 per light. If you only need to replace the light bulb, plan on paying about $20 to $100 per light. The largest cost factors include the type of pool light, the number of pool lights needed, and the labor costs in your location. But additional cost factors include work required on existing wiring, other repairs, and the continual maintenance needed to keep your pool light in good working condition after installation.

The average cost to install outdoor or landscape lighting is around $4,000, with most projects ranging from $2,000 to $6,000. The total cost can vary widely depending on several factors, including the number of fixtures, design complexity, and the type and quality of the lights used, such as wall sconces, pathway lights, or lamp posts. Other factors that influence the price are the square footage of the area being lit, the amount of electrical work needed, any required excavation or trenching, and local permitting costs. For specific types, you might pay around $100 for pathway or string lighting and up to $700 for lamp post lighting.

While wet-rated and damp-rated lighting is designed to handle contact with moisture, there’s a difference between the two. Wet-rated lighting is safety-rated to be placed in areas with direct exposure to water, including your shower. Fixtures classed as wet-rated are made with waterproof seals to protect the filament and other electrical components from water and moisture. 

Damp-rated fixtures can be used in places with some moisture contact, but not direct exposure. They don’t have the same waterproof seals used in wet-rated fixtures. Damp-rated lighting can be used on your bathroom ceiling or along a wall outside of your shower.

If half of a string of Christmas lights is out, it is likely because of a single burned-out, loose, or broken bulb within that section. Long strands of lights often contain more than one circuit, so when one bulb fails, it can cause the entire circuit (or half the strand) to go dark. To fix this, inspect the unlit section and test each bulb to ensure it is tight and functioning properly. Replacing the faulty bulb or repairing a damaged shunt will typically solve the problem.