Get matched with top countertop and backsplash pros in Marion, VA

It’s generally safe to use a Magic Eraser on quartz countertops. Magic Erasers are made from melamine foam, a gentle abrasive that can remove scratches and stains from various surfaces. Although using abrasive cleaners on quartz is not recommended, the melamine foam is gentle enough to remove minor stains and scratches without permanently damaging the quartz countertops.

You can cut countertops without chipping by using your saw correctly and having a new fine-toothed blade. You can also put masking tape on the front of the countertop material across the cut line and cut from front to back. However, it is very hard to cut countertops without chipping them, especially if they are made of stone or more fragile materials like laminate. The best advice is to know how to use the equipment, use the correct cutting method for the material, cut from back to front, move slowly, and practice on scrap material first.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.

Avoid using harsh, gritty, or abrasive cleaners and sponges on Formica countertops. This includes steel wool, scouring pads, and strongly alkaline or acidic cleaning products like chlorine bleach, oven cleaner, drain cleaner, furniture polish, or vinegar. These can compromise the surface, leading to scuffs, discoloration, and other damage that will reduce the countertop's longevity. Additionally, never place hot items, such as pots and pans directly from the oven or stovetop, onto the laminate surface, as the high heat can cause it to scorch.