Get matched with top dishwasher installation pros in West Bountiful, UT

To clean an old dishwasher without a filter, start by removing the bottom rack to access the drain area. Use a damp cloth or sponge to wipe down the interior, paying special attention to the corners and crevices where food particles and debris can build up. Pour a cup of white vinegar into a dishwasher-safe bowl and place it on the top rack, then run a hot water cycle to help break down grease and grime. After the cycle, sprinkle a cup of baking soda across the bottom of the dishwasher and run a short hot water cycle to deodorize and further clean the interior. 

A clogged air gap can cause a dishwasher not to drain. There are, however, other potential issues that can lead to improper drainage. For example, if you have attached the air gap to a garbage disposal and forgotten to remove the knockout plug, wastewater may backflow into the dishwasher. Check that the air gap is installed properly, and then look for clogs in the air gap and dishwasher filters. 

Basic maintenance, such as cleaning filters, is DIY-friendly, but repairs involving electrical components, pumps, or valves should be handled by a professional.

Water is sitting at the bottom of your dishwasher, likely because the filter is dirty with food debris or because the drain hose has a clog. If the water is still sticking around after following the steps above, it’s time to contact a local plumber.