Get matched with top doorbell installation pros in Washington, UT

It’s best not to install a radiant barrier directly under insulation because it requires an air gap on at least one side to work properly. Instead, you should install the radiant barrier over your existing insulation to create an air space to reflect the radiant heat.

Doubling the insulation in your home also doubles the R-value of said insulation. In other words, by adding more insulation, you can reduce the heat loss by half. Most homes benefit from increasing insulation. Older homes, in particular tend to have less insulation as is, so doubling your insulation could drastically reduce your energy bills, keep your home more comfortable, and take the strain off your HVAC system.

You do not always need to remove old insulation before adding new. If the existing insulation is in good condition—not wet, physically damaged, moldy, or infested with pests—you can add new insulation directly on top of it for a compounding effect. You can also mix different types, such as adding blown-in insulation around existing fiberglass batts.

However, removal is recommended if the old insulation is compromised by water damage or pests. You should also remove it if you plan to install a different type of insulation, like switching from roll or batt insulation to spray foam. If the existing insulation is very old or damaged, you will likely get more benefit from removing it and starting fresh.

Yes, you can install insulation behind drywall yourself, but only if your walls are not finished. If your studs are exposed, installing fiberglass insulation in roll or batt form is very straightforward and just requires a few tools and some safety equipment. If your walls are already finished and you’re looking to add insulation, it’s better to hire a professional, as you’ll likely need blown-in insulation, which can be dangerous to work with and a challenge to get into the proper areas in your wall voids.