Best sink repair pros near Murray, UT

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.

There are few things more annoying than trying to fall asleep only to be woken up by the sound of a dripping faucet. If the faucet drips when the water is off, it probably has a loose or damaged seat washer. The screw gets loose from repeated use, making the faucet drip. With outdoor faucets, this is more common in the summer when people are using it more often to water the garden or cool off. Disassembling the faucet and tightening or replacing the seat washer and screw can get the dripping to stop.

Hiring an emergency plumber is expensive because of the urgency and inconvenience, but there are a few things you can do to help keep costs down:

• Minimize water damage by shutting off your water main 

• Clean up pooling water immediately to reduce damage and mold growth

• Avoid using fixtures if you have a clog or septic system backup

• Verify that your plumber is licensed before hiring

• Call a few plumbers for estimates if you can afford a short delay in getting service

Putting in a new bidet attachment or seat requires as little as 30 minutes. Installing a full bidet toilet or stand-alone bidet might take one to three hours. Additionally, if you need a GFCI outlet installed, that can take 30 minutes to three hours depending on the complexity of the job.