Top-rated plumbers.

Get matched with top plumbers in Monroe, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your plumbing project in Monroe, UT?

Select your specific project to find the pro for you.

Find Plumbers in Monroe

Avatar for Bath Fitter
Bath Fitter
3.9(
26
)

Serving Monroe, UT and surrounding areas

Approved

In business since 2010

Free estimates

Credit card accepted

"Brandon, Tg,were excellent. They were on time, worked well together, let us give feedback, cleaned up as they went along, made sure we knew what was happening during each step. I could not be happier, our shower was 30+ yrs. Pretty bad shape... I am so excited to have a new shower, that I didn't have to wait 2 to 3 weeks for... Cost was very affordable... The person who came to our house from Bath fitter,was knowledgeable, and product I believe is made in the USA.. Our installers were wonderful... They did such a wonderful job... Thanks Bath Fitter M B"
Shower
Response time1 day
Response rate98%
233 neighbors recently requested a quote
Avatar for Neli Virtual Appliance Repair
Neli Virtual Appliance Repair
4.2(
647
)

Serving Monroe, UT and surrounding areas

Approved

In business since 2016

Free estimates

Warranties offered

"I hired Neli over a week period for 3 different appliances, my dryer, washing machine, dishwasher, and even kitchen sink! I had a fantastic experience: 1. I fixed my dryer with Thomas' excellent remote guidance, changing the timer and the switch! Fabulous guidance Thomas, with lots of money saved! I learned a lot in the process. 2. I determined that there was no dishwasher leak and in the process learned how to check for leaks and trouble shoot for some common repair issues. It cost $40.00 but as I had some water on the floor, I was ready to get a new dishwasher. Now, I am confident that it wasn't a leak and caused by putting in the dishes in a funny manner and not a repair issue. I am using the dishwasher now again with no problem. 3. I determined with Thomas' help that the washing machine had a major problem and could have spun out of control into my wall....no question, it was time to get a new washing machine! This was a well spent $40.00--I even got Thomas advice on purchasing a new washing machine and what to look for. 4. I checked the drainage on my kitchen sink and learned how to empty out the "trap" and that most likely, I am okay, but what to swap out if I have continuing issues with slow drainage. In the end, I saved lots of money, gaining and learning valuable experience! Absolutely fabulous service!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Response time1 day
2 neighbors recently requested a quote
Recommended by89%of homeowners
DaBella - St. George (Bath/Siding)
3.4(
615
)

Serving Monroe, UT and surrounding areas

Approved (Corporate)

In business since 2011

Free estimates

Credit card accepted

We are the premiere home improvement company, with service and products that will keep you happy for years to come.\n\nOur customers receive unmatched warranties and exclusive products. We offer exclusive roofing, siding and window systems that are manufactured in America and installed by factory-trained installers, delivering the best possible result every time.\n\nDaBella Baths is our exclusive bath division, specializing in tub and shower conversions, bathtub replacement, walk-in showers and walk-in tubs.\n\nIf you want to work with a contractor who is passionate about service, committed to quality and determined to delight you, then DaBella is for you!\n\nWe?re ready to turn your dreams into a beautiful reality.\n

1 neighbors recently requested a quote
Recommended by86%of homeowners
Avatar for Vortex Filtration Inc
Vortex Filtration Inc
5.0(
5
)

Serving Monroe, UT and surrounding areas

In business since 2000

Free estimates

Emergency services offered

"Vortex Filtration Inc is a excellent company with vast experience & knowledge in conditioning potable well water. I recommend Vortex Filtration Inc to design build and install their patented Vortex water system to solved all well water conditioning issues. My client had a problem for over tens years prior to the installation of the Vortex system. Once installed, the well water in the holding tank was crystal clear. Thanks Vortex!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+9

Recommended by100%of homeowners
Avatar for Bathworx Inc.
Bathworx Inc.
5.0(
3
)

Serving Monroe, UT and surrounding areas

In business since 2023

Free estimates

Warranties offered

"The possibilities are endless with design and products, and pricing was affordable. Very experienced workmanship and knowledge made this project easy and enjoyable. We highly recommend BathWorx and have plans to use their services again at our summer home remodeling project of two bathrooms."
Shower in Veincut Gray
Golden Beaches with Designer border
Shower1
White Pearl
Brecia wall panels with wainscoting

+1

Response time3 hrs
Response rate100%
Recommended by100%of homeowners
Replumb Specialties Inc.
3.9(
9
)

Serving Monroe, UT and surrounding areas

In business since 1992

Free estimates

Warranties offered

"RSI is a great replumb company. The actual replumbing was outstanding and we opted for the upgraded pro-plex fittings to increase our warranty from 10 to 25 years (not an up sell by Jamey - our choice). They also put in-place a dedicated recirculation line for our tankless water heater. The RSI team (Kenny and Milo) was expert at locating and replacing the old polybutylene piping with minimal impact to sheetrock, tiles, and fittings. They finished the work early but were delayed in finalizing the project due to a delay from the Regional Building Inspectors, not RSI's fault. Our only suggestions are 1) better daily clean-up, 2) better attention to detail repainting sheetrock (we had to repeatedly point out areas for a 'redo' and adjacent areas for touch-up) - this seemed harder to do that we expected (this is why we gave them a B rather than an A for quality). Jamey was very responsive to us and answered our questions/concerns thoroughly and promptly. We will recommend RSI our neighbors and friends.
"
Recommended by85%of homeowners
Avatar for Homemade Design
Homemade Design
3.7(
322
)

Serving Monroe, UT and surrounding areas

In business since 2006

Credit card accepted

"We used it for our son’s nursery.  We were not completely satisfied with the service as the deal did not include as much as we expected.  The company was fine but we would not purchase this deal again."
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Showing 1-10 of 26
Plumbing questions, answered by experts

The plumbing industry has standardized the sizes for bathtub drains. They are 1 1/2 inches wide to fit all standard bathtubs from 14 to 26 inches deep. The standard sizing is to ensure that the drain fits into the P trap, a special part of your piping that prevents sewer water from bubbling up into your home (yuck).

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.

When learning how to design a plumbing system for a house, it's helpful to know that ABS pipes have fallen out of favor because they are less safe and efficient compared to alternatives. ABS pipes are made from a chemical called bisphenol (BPA) that may cause neurological and hormonal effects. Due to the fact that it has a lower melting point, ABS can also be flammable in high-temperature situations. Finally, ABS is prone to warping caused by heat and UV exposure. It can also fracture in frozen conditions.

Plumbing installation costs in renovations typically range from $300 to $1,500 or more, depending on the complexity and specifics of the project.

Whether a pot filler is worth it depends on your cooking habits, budget, and kitchen layout. For avid home cooks who frequently prepare pasta, soups, or stocks, the convenience of filling large pots directly on the stove can be a significant benefit. A pot filler can also add value to a home, attracting potential buyers with its combination of luxury and utility. However, the installation can cost around $800. The return on this investment is highest in larger kitchens where the sink is far from the stove. In smaller kitchens, where the sink is nearby, a pot filler might be perceived as an unnecessary feature by some homeowners or potential buyers.

The Monroe, UT homeowners’ guide to plumbing services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"