Get matched with top marble and granite pros in Moab, UT

The frequency for sealing marble countertops depends on several factors, including the quality and color of the stone, the type of sealant used, and the amount of traffic the surface receives. Marble has a porous surface that requires sealing to maintain its shine and resist scratches. As a general rule, you should seal countertops at least once a year. However, for heavily used surfaces, like those in a busy kitchen or family bathroom, you may need to reseal them every three to six months. Conversely, countertops in a rarely used guest bathroom might only need resealing every few years.

Yes, limestone often turns yellow over time when improperly cared for. The stone contains natural iron deposits, which can oxidize when exposed to water, acids, or harsh chemicals, such as bleach. Without exposure to water or chemicals, limestone should not turn yellow. Always seal limestone countertops to protect them from moisture, and only use gentle cleansers designed for stone.

If the damage is minor, you can repair countertops without replacing them. You can also resurface a laminate countertop rather than replace it when it gets old and dingy. Countertop resurfacing is a relatively easy project, though it can be time-consuming, so you may prefer to hire a pro to do this for you.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.