Get matched with top well and pump technicians in Lapoint, UT

Well pump repair might be covered by your homeowner’s insurance, but it’s typically not. If the damage results from a major storm in your area, flooding, a fire, or some other natural catastrophe, then you should consider filing a claim for the damage. However, if the issue is the result of an aging well pump, your policy will very likely not cover the repair cost. In either case, you should hire a well pump professional inspect your well pump, and then use that information to decide whether or not you should file a claim.

Servicing includes cleaning filters and coils, checking coolant levels, and inspecting electrical connections.

For the most part, choosing between 30/50 psi and 40/60 psi is based on your water-pressure preference. However, it can also depend a little bit on your house—if you have older plumbing, a lower water pressure can be easier on the pipes (and a bit more gentle on your well pump). 

The lower 30/50 pressure is usually enough for a single-story home, but you may want 40/60 if you have multiple stories, as the extra pressure helps water flow smoothly up to the second floor.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.