Top-rated well and pump technicians.

Get matched with top well and pump technicians in Daniel, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Daniel, UT?

Select your specific project to find the pro for you.

Find Well and pump technicians in Daniel

One Home
New to Angi

Serving Daniel, UT and surrounding areas

Approved

Hello! I am a returned missionary and have been doing plumbing since i have been home. My name is Siosifa Lavulavu. I have installed a countless amount of toilets and have experience putting together bathrooms and all of a kitchen and have a lot of experience with cleaning drains, finding leaks, installing and replacing water heaters and especially clearing out blockage in main lines. I can do same day calls and am very flexible with pricing. \n\nMy number 385 299 4835

1 neighbors recently requested a quote
Avatar for Will Stott LLC
Will Stott LLC
New to Angi

Serving Daniel, UT and surrounding areas

Approved

Hello potential customers! I recently got my General Contractors license and am looking for opportunities to serve and earn your trust. I'm a father of 3 with a passion for creative problem solving, quality work, and excellent customer service. My primary background is in plumbing, but I've done a little bit of everything: concrete work, framing and fine wood work, sheetrock, excavation and landscaping, demo, junk removal, restoration... I believe I have the right mindset and skill set to be able to solve most home related prices honestly and optimally! I would love the opportunity to earn your business

Avatar for Expert Plumbing Heating Air & Electrical
Expert Plumbing Heating Air & Electrical
4.7(
267
)

Serving Daniel, UT and surrounding areas

In business since 1996

Free estimates

Emergency services offered

"Dan from Expert Plumbing called me about 10:15 AM on the day of the new shower installation to get some additional information on what I needed done, and then again when he was about 10 minutes out. When he arrived, just shortly after 11 AM, he went over Expert's pricing (i.e., cost of the service call, hourly rate and minimum,etc.) and after looking very briefly at the plumbing, had me sign an invoice assuming two hours of labor (the worst case scenario in his mind). However, he explained that if he completed the work in an hour or less he would write up another invoice for one hour minimum labor charge. Dan then looked at the now exposed plumbing behind the bathtub. He saw no evidence of any leakage along the bathtub piping or on the floor during a careful inspection. However, he was unable to pressure test the piping and soldered connections because the water had been turned off and the shower-install contractor had already cut the copper piping to the now-demolished shower. He then focused on the corroded (due to hard water) nipple. It took some effort but with the correct internal pipe wrench he was able to remove it. I had purchased four nipples of differing lengths in anticipation of replacing the corroded nipple. Dan installed one of the new nipples so that a new tub spout with a threaded connection can be installed. Overall, the labor he performed took around 45 minutes, with most of that time expended on removal and replacement of the recalcitrant corroded nipple. In summary, Dan was courteous, personable, and professional. Before leaving he modified the invoice to one hour of labor, as he had discussed upon arrival. I would use Expert Plumbing, Heating, Air, and Electrical again if needed."
Recommended by87%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)

Serving Daniel, UT and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Integrity Plumbing LLC
5.0(
1
)

Serving Daniel, UT and surrounding areas

In business since 2016

Free estimates

Emergency services offered

We specialize in a variety of residential and commercial services and take pride in the attention to detail put into each of the projects we're involved with. We're known for our quality work and the integrity of our business. We look forward to building long-term relationships with our clients, and guarantee your satisfaction.

Recommended by100%of homeowners
Reitze's Plumbing
New to Angi

Serving Daniel, UT and surrounding areas

In business since 2020

Free estimates

Credit card accepted

Reitze's Plumbing is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Showing 1-10 of 12
Wells and Pumps questions, answered by experts

Consider replacement if the pump is over 10 years old or has recurring, costly issues.

Yes, you can oversize a well pressure tank without harming your well system, as there are no major risks involved. The primary advantage of a larger tank is an increased lifespan due to less frequent pump cycling. Fewer startups and longer, slower runtimes mean less wear and tear on the system and can help conserve energy. The main drawbacks are the higher upfront cost and the larger amount of space required for an oversized tank. While not necessarily a bad thing, it is often more efficient to select an appropriately sized tank to save money and space.

Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

If your well pump gets stuck in its casing, you may be able to free it loose by gently wiggling the line or by vibrations from tapping the line with a hammer. However, if your pump is stuck in a buildup of minerals around the casing, you’ll probably have to call in a well pump contractor to get it out. They’ll likely use a muriatic acid solution—a strong, corrosive acid—to break down the minerals and free the pump loose. 

To avoid a stuck pump in the future, experts recommend a professional well cleaning once every 10 years. 

The Daniel, UT homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.