Get matched with top deck repair pros in Fillmore, UT

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

Building a deck isn't too hard if you’re handy with carpentry, have the necessary tools, and are willing to put effort into it. However, other factors, such as plans, permits, and design, can be hard if you don’t have experience in those areas.

Note: You’ll need another person to help you build the deck (especially for framing and setting the beams). Building a deck yourself will be very difficult if you don’t have an extra set of hands to help.

Before installing any materials under the deck for removing moisture, you should perform some prep work on the ground. Work the dirt under the deck to create a grade away from the home. A grade of at least six inches for every 10 feet works well. Do not leave a gap between the dirt and the home’s foundation where water could pool. Once you or a contractor regrades the dirt under the deck, you then can add materials over the top.