Top-rated concrete finishing pros.

Best concrete finishing pros near Central, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete finishing project in Central, UT?

Select your specific project to find the pro for you.

Top-Rated Concrete finishing pros in Central - Updated Nov 2026

Avatar for Immortal concrete LLC
Immortal concrete LLC
5.0(
1
)
Concrete Flatwork - Repair & Resurface

Serving Central, UT and surrounding areas

In business since 2024

Free estimates

Emergency services offered

"Removed Concrete, took it away where needed, graded area and improved grading of area. Formed the new driveway and patio area. Placed reinforcing steel. Brought in a good crew and poured the and finished the concrete to perfection. They were so Polite and Respectful and Nice. They did a very good job. The area is more usable now and is beautiful."
Foundation repair
Pouring 6’ foundations 4000psi
Just finished pouring and broom finishing the concrete surface
Foundation repair
Foundation repair

+17

Recommended by100%of homeowners
Showing 1-10 of 27
Concrete Finishing FAQs, answered by experts

Yes, cinder blocks must be primed before painting. Without primer, your paint won't stick to the surface of the blocks. You should use a bonding and filling primer which fills all of the small pores of your blocks. Once the primer dries, you'll have a smoother surface to work with and your paint will stick easily to the blocks.

For homeowners, it’s better to dry grind concrete. Dry grinding is the method described above and can be done by experienced DIYers for smaller projects. Wet grinding requires a big volume of water, a way to collect the slurry created by the water and dust, and an environmentally-safe place to dispose of the slurry. In general, only professionals do wet grinding.  

In most cases, you are good to stamp the concrete one or two hours after you pour it, but perform the thumb test mentioned above. You want the concrete to be dry enough so the stamps don’t sink, but wet enough that the stamps make a successful imprint. In general, this is a tricky question, as it also depends on the weather outside, the time of day, and the size of the poured concrete slab.

Polished concrete gets its glass-like finish from several rounds of polishing, using increasingly finer grit diamond grinding pads. The concrete’s hardness will determine which grits you need to get your desired finish. The densifier and sealer also contribute to the look of the final floor, so either talk to a concrete pro (or hire one) to achieve the right concrete floor finish.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

The Central, UT homeowners’ guide to concrete finishing services

From average costs to expert advice, get all the answers you need to get your job done.