Get matched with top deck maintenance specialists in Bear River City, UT

PVC decking can get slippery when wet because it’s made from plastic. However, composite and wood decking can also be slippery when wet. It’s best to wear shoes with grippy soles when walking on a wet deck, no matter the material, and to be extra cautious not to slip and fall down.

Applying too much sealer to a deck might seem like extra protection, but it can cause more harm than good. Wood is a porous material with a limited capacity to absorb liquids. When you go overboard with sealer, the excess can't soak in and instead forms a film on the surface. This leftover layer is prone to peeling, cracking, and trapping moisture, ultimately defeating the purpose of sealing in the first place. 

Yes, adding a composite deck, such as one made from Trex, can significantly increase your home's value. It is a valuable home renovation for recouping costs, with some estimates for return on investment (ROI) ranging between 60% and 70%. More recently, Remodeling's 2024 Cost vs. Value Report suggests a deck addition has an ROI of 82.9%, with an average resale value of nearly $14,600. A new deck makes your yard more functional, enhances the landscape's aesthetic, and can entice prospective buyers. The investment may have a higher return if the deck adds usable square footage to the property.

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.