Get matched with top stone countertop pros in Rosharon, TX

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.

Yes, a granite countertop can be cut in place. However, learning how to cut a granite countertop in place is a lot trickier than cutting granite in an open, well-ventilated space. You’ll also need to protect everything in the surrounding area (like your kitchen cabinets and appliances), but even that might not be enough to prevent dust from getting stuck in tight spots. If you absolutely must cut a granite countertop in place, consider hiring a pro to get the job done in the cleanest and safest way possible.

The best tool for cutting countertops depends on the type of countertop material. For some softer materials, like laminate (Formica) and butcher block, you can use a hand saw, but most experts recommend power saws like circular saws, since these make the job go faster and easier and give more even results. However, power saws and circular saws are dangerous if used incorrectly, and they can be so powerful that they damage or chip laminate, stone, and other types of countertops. For this reason, you should take safety precautions and use best practices to prevent damage.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.