Get matched with top pool table assembly pros in Rancho Viejo, TX

Building an inground pool is a job best left to the pros. Excavating the area and building the pool requires heavy equipment and specialized training, and pools have complex plumbing and electrical systems. Unless you’re experienced in these areas, you’re better off hiring a pool contractor to make sure the job gets done safely and correctly. 

The time it takes for a pool heater to heat a pool can range from eight to 48 hours, with an average of about 12 hours for the initial heating. For a more specific example, an average-sized 15,000-gallon pool may take six to 10 hours to heat up by 10 degrees. The exact duration depends on several factors, including the pool's size, the type and size of the heater, the starting water temperature, and the outside air temperature. It may take some trial and error to determine the precise time your specific pool takes to reach a desired temperature.

Generally, you do not need to drain your pool to convert it to a saltwater system. The main exception is if you have used an antibacterial agent containing polyhexamethylene biguanide to sanitize your pool, as these sanitation products do not mix well with saltwater systems. If this is the case, you will need to start fresh. You can either drain the pool or treat the existing water with a high dose of chlorine to remove the antibacterial agent. If you choose the chlorine treatment, wait several days to allow the chlorine to work before proceeding with the conversion. If you are unsure whether this applies to your pool, consult a pool technician.

You can check if your pool is bonded by looking for a copper wire that connects to the motor and pumps and then extends into the ground. However, if you’re unfamiliar with electrical wiring, contacting a pool electrician to inspect the motor and pumps is safest. An electrician can check the system and determine if it is up to code and meets all swimming pool bonding requirements.