Get matched with top structural engineers in New Boston, TX

Q: What is the 10 10 rule in construction?

• <div><p>The 10 10 rule describes the formula most contractors use to determine how much to charge for a job. Allowing for 10% overhead above the total projected cost to do the work and 10% profit sets a contractor up for success, even if there are delays or other problems on the project. This formula isn&rsquo;t a hard-and-fast rule, but it is a ballpark figure to begin with when estimating your expenses on a job.</p></div>

Q: Are brick houses safer in an earthquake?

• <div><p>According to the <a href="https://www.earthquakecountry.org/step4/urmwalls/#:~:text=Houses%20built%20of%20unreinforced%20masonry,and%20the%20roof%20is%20critical.">Earthquake Country Alliance</a>&mdash;a public and private alliance in California that works to improve earthquake and tsunami readiness&mdash;reports that unreinforced masonry, such as stone, bricks, and hollow clay tiles, is more susceptible to earthquake damage. The mortar between bricks isn&rsquo;t as stable as other building materials and methods.</p></div>

Q: How do you know if a wall is load-bearing?

• <div><p>The easiest way to <a href="https://www.angi.com/articles/load-bearing-wall.htm">tell if a wall is load bearing</a> is to check if it&rsquo;s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don&rsquo;t fit into these categories can still be load-bearing. If you&rsquo;re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.</p></div>

Q: How do professionals incorporate framing into existing structures?

• <div><p>By careful planning and reinforcement to maintain structural integrity.</p></div>

Q: How high can you build a single brick wall?

• <div><p>A freestanding brick wall that's only one brick thick can usually stand six to eight feet high. If you need a higher wall, it should be at least two bricks thick for adequate stability, and it might require a footing to support the added weight. Additionally, some areas have regulations and codes dictating how high a brick wall can be, so check with local code enforcers to ensure your proposed wall complies with any regulations.</p></div>

Enter your zip and get matched with up to 5 pros

Need a pro for your structural engineering project in New Boston, TX?

Select your specific project to find the pro for you.

Verified Reviews for Structural Engineering pros in New Boston, TX

*The Angi rating for Structural Engineering companies in New Boston, TX is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Structural Engineering needs.

*The HomeAdvisor rating for Structural Engineering companies in New Boston, TX is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Structural Engineering needs.

Last update on January 13, 2026

Reviewed in January 2026
I had a great experience getting the various tasks completed around my home. I would definitely recommend.
TR Property Maintenance
Request a quote
Reviewed in April 2024
L&A did a great job in removing the shop debris. Thanks!
L&A Junk Removal Services
Request a quote
Reviewed in January 2024
Tony Thompson had excellent follow though, great communication, clear understanding of our custom build. I would highly recommend him! I had no doubt he would make the best choice for me when I could not be there. He is one of the most highly organized builders I have ever dealt with. Itâ s...
Tony Thompson Construction, LLC
Request a quote
Reviewed in October 2023
TSSC did my ceilings, flooring, upgraded my bathroom and painting. Did a great job in a respectable time. Would use them again.
TSSC Enterprises Metal Works & Construction
Request a quote
Reviewed in December 2022
They were prompt in the bid and even waited patiently for the first contractor , who was late. D&D were very professional , both Dustin and Derrick are very nice guys, I had no worries with working with them. I would definitely recommend them to anyone wanting a professional and and above and...
D&D Services
Request a quote
Reviewed in June 2022
I am new to the area and the first Tree Service I called, which is located about a mile from my house, wouldn't even come and look at the 5 large trees that I needed trimmed. I called Hawkins Tree Service and Josh came out the very next morning. He gave me an estimate and that ended up being...
Hawkins Tree Service
Request a quote
Reviewed in March 2022
Texas Pressure and Soft Wash came and cleaned our storage building and our boat shed. He arrived punctual at his appointed time. He did an exceptional job on both structures. He was very polite and left everything in its place when he was finished. I would definitely hire him again, and would...
Texas Pressure & Soft Wash
Request a quote
Reviewed in March 2022
Very reasonable, quick, and thorough. Planning more work with them already.
Arklatex Remodeling and Tree Service LLC
Request a quote
Reviewed in October 2021
Seth is very knowledgeable, prepped area and used protective covers on floor and surrounding furniture as well. This was a first in comparison to others I hired before. Provided an in depth evaluation and service on fireplace and chimney. Very impressed to say the least!
Hammer's Chimney Service
Request a quote
Reviewed in August 2021
Great, in fact have hired them to remodel kitchen and too date they are doing a great job, attentive to small changes and moving quicker than I expected
C & S Handyman Services
Request a quote

Find Structural engineers in New Boston

PJM Structural

4.9(

)

Serving New Boston, TX and surrounding areas

Approved

In business since 2023

Free estimates

Emergency services offered

"I had an urgent request to get a permit across the line and Pedro was on his A-game and helped me within hours. Very professional, well documented, etc. Other structural engineers I hired only gave me headaches. I'd use Pedro again any day. Thank you very much, and glad to be in business with you!"

+15

Response time4 hrs

Response rate86%

Recommended by100%of homeowners

Serving New Boston, TX and surrounding areas

Approved

In business since 2013

Free estimates

Warranties offered

"He was very professional and insightful about the foundation and the slight slope I did not notice until he pointed it out will use him again."

Response time3 days

2 neighbors recently requested a quote

Recommended by100%of homeowners

Request Quote

PDK House Leveling and Foundation Repair

5.0(

)

Serving New Boston, TX and surrounding areas

In business since 1997

Free estimates

Emergency services offered

"The staff was professional and timely. The cost was low compared to other service providers. Also, the free estimates were great!"

+10

Recommended by100%of homeowners

Request Quote

Structural Engineering questions, answered by experts

The 10 10 rule describes the formula most contractors use to determine how much to charge for a job. Allowing for 10% overhead above the total projected cost to do the work and 10% profit sets a contractor up for success, even if there are delays or other problems on the project. This formula isn’t a hard-and-fast rule, but it is a ballpark figure to begin with when estimating your expenses on a job.

According to the Earthquake Country Alliance—a public and private alliance in California that works to improve earthquake and tsunami readiness—reports that unreinforced masonry, such as stone, bricks, and hollow clay tiles, is more susceptible to earthquake damage. The mortar between bricks isn’t as stable as other building materials and methods.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

By careful planning and reinforcement to maintain structural integrity.

A freestanding brick wall that's only one brick thick can usually stand six to eight feet high. If you need a higher wall, it should be at least two bricks thick for adequate stability, and it might require a footing to support the added weight. Additionally, some areas have regulations and codes dictating how high a brick wall can be, so check with local code enforcers to ensure your proposed wall complies with any regulations.

The New Boston, TX homeowners’ guide to structural engineering services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

Timothy Moore
•
May 30, 2026May 30, 2026
How Much Does It Cost to Install an LVL Beam? [2026 Data]
Looking to remove load-bearing walls and vertical supports to open up your living space? Learn about what affects the cost to install an LVL beam.
Alison Kasch
•
Apr 4, 2026Apr 4, 2026
How Much Does It Cost to Remove a Load-Bearing Wall? [2026 Data]
Do you have a load-bearing wall standing between you and your projects that you want to remove? Learn about the cost of removing a load-bearing wall.
Dan Simms
•
May 30, 2026May 30, 2026
How Much Does a Structural Engineer Cost to Hire? [2026 Data]
The cost of a structural engineer is easily justifiable given the value they bring to the table. Use this guide to see what hiring your professional will total.
Kate Fann
•
Mar 19, 2026Mar 19, 2026
Who Do You Hire to Knock Down a Wall?
Looking to open up your living space and need to remove a wall? Learn who to hire to knock down a wall, whether it's load-bearing or non-load-bearing.
Kyle Schurman
•
Mar 19, 2026Mar 19, 2026
Who to Hire to Replace a Sill Plate?
A sill plate needs to be replaced when it starts to rot out. Use this guide to help you know who to hire to replace a sill plate at your home.
Rachel Hoffman
•
May 3, 2026May 3, 2026
10 Signs of Structural Damage in Your Home
Keeping your home safe and structurally sound should be a top priority. Learn to recognize the signs of structural damage you should never ignore.