Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Mertzon, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Mertzon, TX?

Select your specific project to find the pro for you.

Find Deck cleaning pros in Mertzon

Avatar for Elite Lawn Care - Home  Facebook
Elite Lawn Care - Home Facebook
3.7(
5
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Mertzon, TX and surrounding areas

In business since 2010

Free estimates

Credit card accepted

"I have been using Elite lawn care for over 10 years, from monthly yard maintenance to rock beds, sidewalks, steps and replacing my deck. Mr. Hildebrand is always punctual and courteous and is very knowledgeable of his services. I would highly recommend yes services."
Response time2 hrs
Recommended by60%of homeowners
West Texas Sandblasting & Coating, Inc.
New to Angi
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Mertzon, TX and surrounding areas

In business since 2012

With over 15 years of experience in the painting industry, we are the experts you need to take care of your home or business. We handle everything from sandblasting to power washing We will treat your home as we would treat our own. Give West Texas Sandblasting & Coating, Inc., a call today, we look forward to working with you!

Response time3 hrs
Showing 1-10 of 15
Deck Cleaning questions, answered by experts

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Deck boards should be spaced no more than three-eighths of an inch apart. This is enough space to allow water and small debris to pass through without collecting on the surface, but not enough to create a tripping hazard. Certain materials, like pressure-treated wood, shrink over time, so they may need less space at installation.

It depends on the type of wood. The average cost to build a deck out of pressure-treated lumber is $15 to $25 per square foot, but more affordable varieties such as bamboo and cedar cost less at around $3 to $10 per square foot. However, when comparing the cost of vinyl decking versus wood decking, it’s important to also consider ongoing maintenance costs. For example, most woods require regular sealing to keep them protected against weather and rot.

Applying too much sealer to a deck might seem like extra protection, but it can cause more harm than good. Wood is a porous material with a limited capacity to absorb liquids. When you go overboard with sealer, the excess can't soak in and instead forms a film on the surface. This leftover layer is prone to peeling, cracking, and trapping moisture, ultimately defeating the purpose of sealing in the first place. 

The cost to repair a deck is between $900 and $3,500, depending on the cause and extent of the damage. For example, fixing a sinking deck caused by pest damage can cost between $200 and $600, while replacing sinking boards costs between $500 and $4,000.

The Mertzon, TX homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.