Get matched with top marble restoration pros in Los Indios, TX

Overall, granite tends to cost more than marble. Prices for each material will fluctuate depending on the source of the stone, your location, shipping costs, and the thickness of the material. Labor to install marble or granite countertops typically ranges from $35 to $45 per hour. Granite and marble tile and slab costs compare as follows:

• Marble tile: $7–$10

• Granite tile: $5–$15

• Marble slab: $25–$60

• Granite slab: $50–$100

Yes, Corian® and other solid surface materials can be cut with standard woodworking tools, such as a circular saw or a jigsaw. However, it is crucial to use the correct type of blade to avoid damaging the material.

For a circular saw, a tungsten carbide-tipped blade is required; a triple chip grind blade is highly recommended. For a jigsaw, you should use a fine-tooth down-cutting blade. Do not use blades designed for cutting wood, as they can cause microfractures that weaken the edges of the countertop. A diamond blade is also unnecessary, as those are designed for harder materials like natural stone, which Corian is not.

After cutting, the edge will be rough. It is essential to sand and smooth the cut edge to prevent microfractures, which can eventually compromise the integrity of the countertop.

For most homeowners, quartz and quartzite countertops are similar in price. The average quartz countertop installation costs $80 to $220 per square foot, while quartz countertops cost $70 to $200 per square foot. Of course, there are outliers, like if you choose a highly customized, rare natural stone with high-end finishes.

You can cut countertops without chipping by using your saw correctly and having a new fine-toothed blade. You can also put masking tape on the front of the countertop material across the cut line and cut from front to back. However, it is very hard to cut countertops without chipping them, especially if they are made of stone or more fragile materials like laminate. The best advice is to know how to use the equipment, use the correct cutting method for the material, cut from back to front, move slowly, and practice on scrap material first.