Get matched with top deck maintenance specialists in Crossville, TN

The time to build a vinyl deck varies based on factors like size, the complexity of the design, and weather conditions. Generally, a straightforward project might take a few days to a couple of weeks for preparation, installation, and any necessary inspections. However, larger or more intricate designs may extend the timeline. Timely acquisition of permits, efficient planning, and coordination with contractors will all help to make the construction process as smooth and quick as possible.

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.

Covering your deck with a breathable tarp can protect it from snow, ice, and cold winter temperatures. This is a good winterizing solution if you don’t plan to use your deck at all during the colder months. However, it might be best to skip the tarp if you’ll still be walking on your deck or using it in a limited capacity.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.