Get matched with top concrete resurfacing pros in White, SD

Yes, adding a patio or other concrete feature can increase your property taxes, particularly if it's considered a permanent improvement. The general rule is that if the project requires a permit, your property taxes will likely go up.

Permanent structures like a poured concrete patio are considered capital improvements that require a permit, which will trigger a reassessment of your property's value. Other concrete projects that typically increase taxes include:

• Pool decks

• Walkways

• Driveways

• Steps

• Foundations

In contrast, 'temporary' installations, such as a paver or flagstone patio, may not require a permit and are less likely to affect your property taxes.

Permit costs for a concrete patio can range from $75 to $200. While the tax increase varies based on your location and the project's size, it is often a minimal amount. Always contact your local building department before starting a project to confirm permit requirements and any potential impact on your taxes.

Yes, you can pour new concrete over an existing concrete patio. This process, known as resurfacing, is a common repair method used by professionals. For the best results, ensure the old concrete surface is clean and free from debris. The new layer of concrete should be at least three to four inches thick and include reinforcement materials, such as fiberglass fibers or wire mesh, to prevent cracking and spalling. With proper technique, a resurfaced patio can last for 15 to 20 years.

You can pour concrete over existing concrete and then stamp it to create an overlay. The old concrete must be prepared correctly for the new concrete to adhere properly and create a strong, stable surface. Stamping the new concrete creates a patterned finish that adds visual interest and an upscale feel.

Yes—as long as the area has been properly prepped. Different self-leveling brands and compounds have their own specific instructions for preparation; some may require that you add primer or grind the surface. Without proper preparation of the surface, the compound will not be able to fully bond to the concrete and fill the cure as a separate layer, which makes it prone to chipping.