Get matched with top insulation pros in Veblen, SD

If you have access to the foundation walls, adding spray foam insulation to your existing unfinished basement or crawl space is straightforward. Replacing existing insulation in your unfinished attic space is possible after removing the old insulation. However, spray foam insulating an existing wall after the drywall is in place isn’t possible unless you remove most of the drywall.

Heavily exceeding building code requirements for insulation not only wastes money on materials but can also lead to ventilation and moisture problems. In most cases, the minimum amount of insulation required by code is perfectly adequate.

High humidity, bad insulation, warmth from sunlight, and poor circulation are all reasons your home’s hotter inside than out. While this is what you want in the colder months, summer can become unbearable if this is a constant. Try to find the cause, but you need to remember that issues like this require a permanent fix (unless you want to bear down during the summer months).

R-30 insulation is better for higher thermal resistance, but whether it’s "better" depends on the application. R-30 is much thicker and suited for areas like attics or floors in cold climates, where more insulation is required. R-13, on the other hand, is thinner and works well for 2x4 walls or milder climates where less insulation is sufficient. Choosing between R-13 and R-30 depends on the area being insulated and the climate. For example, R-30 provides more insulation but may not fit everywhere in your home.