"Jim is local. It went great. Jim Ferrell is a professional of the highest caliber. Responded quickly, took care of my problems, and advised me as to better means of protection than I had. He came back a second time to uninstall software that I purchased that did not provide adequate protections and installed free software that would do the job. He did the work through remote connection, but is available on site if necessary. For those people needing help on getting red of malware, viruses , etc. on your computer, Jim is local, better than all thse remote out of state location providers, is a mature, highly trained professional in this area. If you go to local computer stores you get very young people that can do a basic job, but are no where near the professional level of Jim. I highly recommend Jim to anyone that needs these type services. "
"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
The cost-efficiency of baseboard heaters depends on the type and how you use them. Generally, standard electric baseboard heaters can be expensive to run because they use electric resistance heating, which is less energy-efficient than systems like forced-air or heat pumps. However, hydronic and gas versions are typically much cheaper to operate. Hydronic models are more energy-efficient because they heat a liquid that retains warmth longer, preventing the thermostat from turning on and off as often. The overall running cost is also influenced by local electricity rates, your home's insulation, and your usage habits. To increase efficiency, you can use baseboard heaters for zoning, meaning you only heat the specific rooms you are using.
Hydronic and standard electric baseboard heaters differ in how they operate, their cost, and their performance. Standard convection heaters use electric coils to heat the air directly, while hydronic heaters warm a contained liquid like water or oil, which then radiates heat into the room.
In terms of cost and efficiency, hydronic heaters usually have a higher upfront price but are more energy-efficient and cheaper to run over time. This is because the heated liquid retains warmth, allowing the heater to continue providing heat for a while after the thermostat turns it off. In contrast, electric heaters provide heat more quickly but are less efficient.
Ultimately, the better choice depends on your priorities. If you need a room to heat up fast and have a lower initial budget, an electric heater might be suitable. If long-term energy savings are more important and you don't mind a slower heat-up time, a hydronic heater is likely the better option.
Unless they are connected to the same system, boilers and water heaters will both need their own expansion tanks. The only case they wouldn’t have separate expansion tanks is if the boiler is pulling double duty and managing a heating system while also supplying hot water for a home. In which case, you may not need a hot water heater.
Most propane boilers last 15 to 20 years with regular maintenance and proper care. The lifespan depends on the quality of the unit, proper installation, and the level of maintenance. Investing in annual service can maximize longevity and efficiency. Routine inspections and timely repairs prevent early breakdown, ensuring your boiler heats your home for years to come.
The cost to install a steam boiler varies depending on the type, fuel used, and your house size. The average cost to install a boiler is $5,900. You could spend $2,000 for a basic electrical steam boiler or up to $9,000 for a high-efficiency oil-burning steam boiler. Boiler installation is a job that’s best left for professionals to complete, and, in some states, only licensed installers can legally complete the job.
The Martin, SD homeowners’ guide to boiler installation services
From average costs to expert advice, get all the answers you need to get your job done.
Discover the average electric boiler installation cost, key price factors, and ways to save. Get transparent, expert-backed estimates for your project.
