Top-rated floor polishers.

Get matched with top floor polishers in Martin, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Martin, SD?

Select your specific project to find the pro for you.

Find Floor polishers in Martin

Dakota Petriwood
New to Angi
Clean & Polish Flooring - For Business

Serving Martin, SD and surrounding areas

Fence and Deck Restoration \n\n\nAt Dakota Petriwood we specialize in exterior wood care. Our restoration services include cleaning, and sealing outdoor structures such as fences, arbors, decks, and play sets.\n\nRestoring is the key to protecting the woods natural beauty and original form.\n\nBenefits of sealing your fence:\n\nWaterproofs Wood \nExtends Wood Life\nMold, Mildew, and Fungus Resistant \nPrevent Cracking and Splitting, Rotting\nPrevent Carpenter ants, and Termites\n\n(Not Sold in Stores)\n\nCall us at 605-951-0045 or visit www.dakotapetriwood.com

Request Quote
Floor Polishers questions, answered by experts

Clean your vinyl plank floors at least one to two times per week with a broom, vacuum, or microfiber mop. You can save the mopping and disinfecting for your deeper cleans about two to three times a month. Keep in mind that if you find sticky spots, spills, or stains, it's best to take care of them ASAP.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Using too much soap or floor cleaner can leave your laminate floors looking dirty or cloudy after mopping. Only use a teaspoon of soap or cleaning solution in a gallon of water. Additionally, always be sure to sweep or vacuum laminate floors before mopping to ensure you pick up dried grit, hair, and dust that can be harder to catch with a wet mop.

Services typically take 2-4 hours, depending on the area size and floor material.

Yes, vinegar and water can strip wax. For a DIY wax stripper, mix about a quarter cup of vinegar with one gallon of warm water. You can also mix one cup of cream of tartar, one cup of white vinegar, and one gallon of water. Before using it on a large area of the floor, you should test it in an inconspicuous place to make sure it works like you want it to.

The Martin, SD homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles