Top-rated well and pump technicians.

Get matched with top well and pump technicians in Lyons, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Lyons, SD?

Select your specific project to find the pro for you.

Verified Reviews for Well And Pump Service pros in Lyons, SD

*The Angi rating for Well And Pump Service companies in Lyons, SD is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

*The HomeAdvisor rating for Well And Pump Service companies in Lyons, SD is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

Last update on November 08, 2025

Find Well and pump technicians in Lyons

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Lyons, SD and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Avatar for Emerald River Plumbing & Drain
Emerald River Plumbing & Drain
New to Angi
Well Pump - Install or Replace

Serving Lyons, SD and surrounding areas

In business since 2025

Free estimates

Warranties offered

Residential Plumbing and Service.\nDrain Clearing, water heater install /repair, home repipes, gas lines, leaking toilets and fixtures. 10 Years Experience

Water heater install
Water heater install
Clogged sewer
Faucets / fixtures
Request Quote
Wells and Pumps questions, answered by experts

If you’re going away on vacation or leaving your home for a long time, it’s a good idea to switch off your well pump and pressure tank before you go. This way you can prevent any damage from unexpected leaks that may occur or unforeseen electrical issues while you’re away.

Although air in your water lines won’t affect the overall quality of your water, it will lead to problems with your well water system if not addressed. Over time, too much air in your water lines can create blockages in your pipes, cause insufficient water flow to your taps and appliances, loosen pipes, and potentially damage important components of your well including your well pump and pressure tank. 

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

The disadvantages of having a well include more maintenance, like annual testing and inspections, and high up-front costs to drill a well. Well water is also vulnerable to contamination, which is why keeping up with testing is important if you own a well. When it comes to well water versus city water, well water does offer more independence and is a reliable water source.

Yes, you can adjust your well pump pressure relatively easily by yourself. You’ll need to remove the cover from your pressure switch and adjust a nut that controls cut-in pressure. Learn more about how to adjust a well pump pressure switch with a step-by-step guide to setting your water pressure.

The Lyons, SD homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles